本論文以水熱法合成氧化鋅和二氧化鈦奈米線，透過無煆燒法合成Zn2TiO4 陶瓷，並以二氧化鈦微量添加進行固態法燒結合成。
在水熱法合成氧化鋅和二氧化鈦奈米線的研究中，藉由控制反應
時間、溶液酸鹼值、反應溫度、濃度等參數，合成高比表面積之氧化鋅和二氧化鈦奈米線，同時具有高純度、均勻性佳、再現性佳等特點，無需昂貴設備即可在低溫下大量生產奈米級粉末。
氧化鋅和二氧化鈦奈米線以無煆燒法合成Zn2TiO4，在低於一千
度的燒結溫度便可燒結成功。Zn2TiO4陶瓷的微波介電特性：k = 24、τf = -25 ppm/oC。
Zn2TiO4添加 2 ~ 12 wt% 的二氧化鈦以固態法燒結合成，由實驗
結果顯示，在燒結溫度970oC 下，添加量x=8 wt.%，此時材料之介電常數(k)為24、共振之品質因數Qxf 為37000；在燒結溫度970oC 下，添加量x=12 wt%，此時材料之共振頻率之溫度飄移係數達τf = 0ppm/oC。材料系統Zn2TiO4+xTiO2(x=2 ~12 wt. %)在低溫下，擁有高Qxf 值、高k 及τf = 0 ppm/oC。

In this paper, The ZnO and TiO2 nanowires were synthesized
separately using hydrothermal method. A calcination-free solid-state sintering process was using ZnO and TiO2 nanowires as starting materials to synthetic Zn2TiO4,and added a trace of TiO2 nanowires for synthesis of solid-state sintering method.
Hydrothermal synthesis of the ZnO and TiO2 nanowires study, by controlling the reaction time, solution pH, reaction temperature,concentration and other parameters, synthesis of high surface area titanium dioxide and zinc oxide nanowire. They have high purity, good uniformity, excellent reproducibility, etc., without expensive equipment can be mass produced nano-powder at low temperature. The ZnO and TiO2 nanowires by calcination-free solid-state sintering process synthesis Zn2TiO4, in less than a thousand degrees can be successfully sintered.Zn2TiO4 ceramic microwave dielectric properties: k = 24, τf = -25 ppm/oC.
Add 2 ~ 12 wt% Titanium dioxide to synthesis Zn2TiO4 of
solid-state sintering method. By the experimental results showed that,Zn2TiO4 at the sintering temperature 970oC, add x = 8 wt%, The microwave dielectric constant (k) for 24, Q x f for 37000. Sintering temperature at 970 oC, add the amount of x = 12 wt. % of TiO2 nanowires,the resonance frequency of temperature coefficient τf = 0 ppm/oC.Zn2TiO4 system, add xTiO2 (x = 2 ~ 12 wt %), at a low sintering temperature, it has a high Q x f value, high-k and τf = 0 ppm/oC.

1 鄭景太, 淺談高頻低損失介電材料, 工業材料, 176期 90年8月.

2 W. J. Huppmann,and G.Petzow,Sintering processes.,New York:Plenum Pr-ess, pp. 189-202, (1979).

3 D. Kajfez,“Computed model field distribution for isolated dielectric resonators,”IEEE. Trans. Microwave Theory Tech., vol. MTT-32, pp. 1609-1616, Dec. (1984).

4 D. Kajfez, “Basic principle give understanding of dielectric waveguides and resonators,” Microwave System News., vol. 13, pp. 152-161, (1983).

5 D. Kajfez, and P. Guillon, Dielectric resonators, New York: Artech House, (1989).

6 Darko Kajfez and Pierre Guillon, Dielectric Resonators, University of Mississippi.

7 David M. Pozar, Microwave engineering Reading: Addison-Wesley, (1998).

8 P. Wheless and D. Kajfez, “The Use of Higher Resonant Modes in Measuring the Dielectric Constant of Dielectric Resonators,” IEEE MTT-S, Symposium Dig., pp.473-476, (1985).

9 Y. Kobayashi and N. Katoh, “Microwave measurement of dielectric properties of low-loss materials by dielectric rod resonator method,” IEEE. Trans. Microwave Theory Tech., MTT-33, 586-592, (1985).

10 Y. Kobayashi, and S. Tanaka, "Resonant modes of a dielectric resonator short-circuited at both ends by parallel conducting plates," IEEE. Trans. MicrowaveTheory Tech., MTT-28, 1077-1085, (1980).

11 B. W. Hakki , P. D. Coleman ,IEEE Trans. MTT ,vol. MTTS ,pp. 402-410 ,(1960).

12 B. Meyer and D. Marx, Phys. Rev. B 67, 035403 (2003).

13 W. S. Hu , Z. G. Liu ,R. X. Wu ,Y.F. Chen ,W. Ji ,T. Yu ,D. Feng , Appl. Phys.Lett. ,71 ,548 ,(1997).

14 M. Chen ,Z. L. Pei ,X. Wang ,C. Sun ,L. S. Wen ,J. Vac. Sci. Technol. ,A 19 ,963 ,(2001).

15 S. Bloom ,J. Ortenburger ,J. Phys. Status Solidi(b) ,58 ,561 ,(1973).

16 施敏,張俊彥, “半導體元件物理與製作技術”, 高立圖書有限公司, 2001 年三版.

17 Y. Chen, D. M. Bagnall, H. Koh, K. Park, Z. Zhu, and T. Yao, J. Appl. Phys. 84,3912 (1998).

18 Z. K. Tang ,G. K. L. Wong ,P. Yu, M. Kawasaki ,A. Ohtomo ,H.Koinuma ,Y.Segawa ,Appl. Phys. Lett. ,72 ,3270 ,(1998).

19 R. A. Laudise ,A. A. Ballman ,J. Phys. Chem. ,64(5) ,688 ,(1960).

20 W. J. Li, E.W. Shi ,W. Z. Zhong ,and Z. W. Yin ,J. Crystal Growth. 203, 186 ,(1999).

21 D.Ulrike ,”The surface science of titanium dioxide”,Surf. Sci. Rep. 48,53,(2003).

22 H.Yin ,Y.Wada ,T.Kitamura ,S.Kambe ,S.Murasawa ,H.Mori,T.Sakata, S.Yanagida,“Hydrothermal Synthesis of Nanosized Anatase and Rutile TiO2 using Amorphous Phase TiO2,”J. Mater. Chem., 11, 1694, (2001).

23 Q.H. Zhang ,L.Gao,J.K. Guo”Preparation and Characterization of Nanosized TiO2 Powders From Aqueous TiCl4 solution”nanostructured materials ,11 ,1293 ,(1999).

24 D. Vernardou ,G. Kenanakis ,S. Couris ,E. Koudoumas ,E. Kymakis ,N. Katsarakis” PH effect on the morphology of ZnO nanostructures grown with aqueous chemical growth” Thin Solid Films ,515 ,8764–8767 ,(2007).

25 Jinping Liu ,Xintang Huang "A low-temperature synthesis of ultraviolet-light-emitting ZnOnanotubes and tubular whiskers”, Journal of Solid State Chemistry ,179 ,843–848 ,(2006).

26 Hyo Tae Kim ,Yoonho Kim ,“Titanium Incorporation in Zn2TiO4 Spinel Ceramics” , J. Am. Ceram. Soc. , 84 ,1081–86 ,(2001).
27 高濂,李蔚,“奈米陶瓷”,五南圖書有限公司,2003年初版一刷.