本論文以全橋相移式換流器架構為基礎，提出多燈管平衡控制方式，而為求有效降低燈管亮度不均之問題，並加增電感-電容平衡電路，期使電路達到自然諧振頻率點之一致及達成燈管之管電流量平衡，同時兼顧電流諧波補償與改善市電功率因數之能力，以確保提昇電源品質及維持供電可靠度，文中並分析探討測試結果，以驗證本論文建議方法之可行性。

Based on the configuration of full-bridge inverters, this thesis has proposed a method to reach a uniform control of multi-lamps, where an L-C circuit was also added in order to better achieve the goal of uniform oscillation frequency and current balance of connected lamps, while ensuring a certain high quality and reliability of supplying power with harmonic compensation and power factor improvement. This proposed approach was analyzed and investigated in anticipation of validating the feasibility of the method proposed.

[1] J. Kahl and F. Dyemartin, “Cold Cathode Fluorescent Lamps (CCFLs),” AI-001, Applications Information, JKL Component Corporation, 1997

[2] J. Kahl, “Understanding Cold Cathode Fluorescent Lamps(CCFLs)—A History and Overview,” AI-007 Applications Information, JKL Component Corporation, 1997

[3] J. Kahl, “Understanding Cold Cathode Fluorescent Lamps(CCFLs)—A History and Overview,” AI-002 Applications Information, JKL Component Corporation, 1997

[4] 黃松輝、洪誌瑋、李佩嫺，”LED光源運用於背光模組之介紹”，自強工業科技基金會，中華民國九十四年五月。

[5] 微機電技術專輯-機械工業雜誌，”TV用液晶顯示器之背光模組技術”。

[6] Harison Toshiba Lighting Corporation, “Cold Cathode Fluorescent Lamp,” 2004.

[7] G. Hsieh, C. Lin and H. Hsieh; “Primary-Side Charge-Pump Dimming Controller for the Cold Cathode Fluorescent Lamp Ballast,” IEEE International Symposium on Electrical and Electronic Technology, Vol. 2, June 2001, pp. 896-900.

[8] J. A. Donahue and M. M. Jovanovic, “The LCC Inverter as a Cold Cathode Fluorescent Lamp Driver,” Applied Power Electronics Conference and Exposition, February 1994, pp. 427-433.

[9] N. Mohan, T. M. Undeland and W. P. Robbings, Power Electronics Converter Applications and Design, John Wiley & Sons, Inc., New York, USA, 1995.

[10] 梁適安, “交換式電源供給器之理論與實務設計,” 全華科技圖書股份有限公司, 民國90年.

[11] 江炫樟 編譯，“電力電子學”，全華科技圖書股份有限公司，民國91年。

[12] Q. Zhao, F. C. Li, P. Xu and J. Wei, “A Simple and Effective Method to Alleviate the Rectifier Reverse-Recovery Problem in Continuous-Current-Mode Boost Converters,” IEEE Transactions on Power Electronics, Vol. 16, No. 5, September 2001, pp. 649-658.

[13] D. Xu, J. Zhang, W. Chen, J. Lin and F. C. Lee, “Evaluation of Output Filter Capacitor Current Ripples in Single Phase PFC Converter,” Proceedings of the Power Conversion Conference, Osaka, Japan, April 2002, pp. 1226-1231

[14] C. S. Moo, H. C. Yen, Y. C. Hsieh and Y. C. Chuang, “Integrated Design of EMI Filter and PFC Low-Pass Filter for Power Electronic Converters,” IEE Proceedings- Electric Power Applications, Vol. 150, No. 1, January 2003, pp. 39-44.

[15] V. Grigore, J. Kyyra and J. Bajamaki, “Input Filter Design for Power Factor Correction Converters Operating in Discontinuous Conduction Mode,” 1999 IEEE International Symposium on Electromagnetic Compatibility, Seattle, Washington, USA, August 1999,Vol. 1, pp. 145-150.

[16] A. C. Wang and S. R. Sanders, “Programmed Pulse width Modulated Waveforms for Electromagnetic Interference Mitigation in DC-DC Converters,” IEEE Transactions on Power Electronics, Vol. 8, No. 4, October 1993, pp. 596-605.

[17] M. Vilathgamuwa, J. Deng and K. J. Tseng, “EMI Suppression with Switching Frequency Modulated DC-DC Converters,” IEEE Industry Applications Magazine ,Vol. 5, No. 6, November/December 1999, pp. 27-33.

[18] Q. Zhao, F. Tao, P. Xu, J. Wei and F. C. Lee, “Improving Performance of Continuous Current Mode Boost Converters for Power Factor Correction,” Proceedings of Power Electronics Specialists Conference, Vancouver, Canada, June 2001, pp. 642-647.

[19] C. K. Tse and M. H. L. Chow, “Theoretical Study of Switching Power Converters with Power Factor Correction and Output Regulation,” IEEE Transactions on Circuits and Systems, Vol. 47, No. 7, July 2000, pp. 1047-1055.

[20] J. Qian and F. C. Y. Lee, “A High-Efficiency Single-Stage Single-Switch High-Power-Factor AC/DC Converter with Universal Input,” IEEE Transactions on Power Electronics, Vol. 13, No. 4, July 1998, pp. 699-705.

[21] Z. Lai and K. M. Smedley, “A Family of Continuous-Conduction-Mode Power-Factor-Correction Controllers Based on the General Pulse-Width Modulator,” IEEE Transactions on Power Electronics, Vol. 13, No. 3, May 1998, pp. 501-510.

[22] J. Rajagopalan, F. C. Lee and P. Nora, “A General Technique for Derivation of Average Current Mode Control Laws for Single-Phase Power-Factor-Correction Circuits without Input Voltage Sensing,” IEEE Transactions on Power Electronics, Vol.14, No. 4, July 1999, pp. 663-672.

[23] M. Magao, “A Novel One-Stage Forward-Type Power-Factor-Correction Circuit,” IEEE Transactions on Power Electronics, Vol. 15, No. 1, January 2000, pp. 103-110.

[24] J. Hahn, P. N. Enjeti and I. J. Pitel, “A New Three-Phase Power Factor Correction (PFC) Scheme using Two Single-Phase PFC Modules,” IEEE Transactions on Industry Applications, Vol. 38, June 2002, pp. 123-130.

[25] M. Qiu, G. Moschopoulos, H. Pinheriro and P. Jain, “A PWM Full-Bridge Converter with Natural Input Power Factor Correction,” 29th Annual IEEE Power Electronics Specialists Conference, Fukuoka, Japan, pp. 1605-1611.

[26] P. J. Villegas, J. Sebastian, M. M. Hernando, F. Nuno and J. A. Martinze, “Average Current Mode Control of Series-Switched Post-Regulators used in Power Factor Correctors, ” 29th Annual IEEE Power Electronics Specialists Conference, Fukuoka , Japan, pp. 1808-1814.

[27] L. Ping, M. Yu, K. Yong, Z. Hui and C. Jian, “Analysis of Single-Phase Boost Power Factor Correction (PFC) Converter,” Proceedings of the IEEE 1999 International Conference on Power Electronics and Drive Systems, Hong Kong, pp. 933-937.

[28] D. Xu, J. Zhang, W. Chen, J. Lin and F. C. Lee, “Evaluation of Output Filter Capacitor Current Ripples in Single Phase PFC Converters, ” Proceedings of the Power Conversion Conference, Osaka, Japan, April 2002, pp. 1226-1231.

[29] Y. L. Lin and A. F. Witulski, “Analysis and Design of Current-Fed Push-Pull Resonant Inverters Cold Cathode Fluorescent Lamp Drivers,” IEEE-IAS Conference Record, 1996, pp. 2149-2152.

[30] M. Jordan and J. A. O’Connor, “ Resonant Fluorescent Lamp Converter Provides Efficient and Compact Solution,” IEEE-APEC Conference Record, 1993, pp. 424-431.

[31] 梁適安 “高頻交換式電源供應器原理與設計,” 全華科技圖書股份有限公司, 民國84年.

[32] L. W. Pierce, “Transformer Design and Application Considerations for Nonsinusoidal Load Currents,” IEEE Trans. Industry Applications, Vol. 32 pp. 633-645, May-June 1996.

[33] S. Maniktala, Switching Power Supply Design & Optimization McGraw Hill, pp. 223-247, 2004.

[34] Z. Xiangjun, L. Hankui, X. Dianguo, ”Analysis and Design of the Flyback Transformer,” IEEE Industrial Electronics Society, Conference, Vol. 1, pp. 715-719, November 2003.

[35] P. Bardos, “Predicting the EMC Performance of High Frequency Inverters,” IEEE Applied Power Electronics Conference and Exposition. Vol. 1, pp. 213-219, March 2001.

[36] C. R. Paul, Introduction to Electromagnetic Compatibility, Wiley-Interscience, 1992.

[37] J. Williams, “A Fourth Generation of LCD Backlight Technology Component and Measurement Improvements Refine Performance,” Application Note 65, Linear Technology Corporation, 1995.

[38] M. Gulko and S. Ben-Yaakov, “Current-Sourcing Push-Pull Parallel-Resonance Inverter (CS-PPRI): Theory and Application as A Discharge Lamp Driver,” IEEE Transactions on Industrial Electronics, pp. 285-291, Vol. 41, No. 3, June, 1994.

[39] M. S. Li, W. J. Ho, and F. Y. Shih, “A Cold Fluorescent Lamp Driver Circuit with Synchronous Primary-Side Dimming Control,” IEEE Transactions on Industrial Electronics, Vol. 45, pp. 249-255, April 1998.

[40] Y. L. Lin and A. F. Witulski, “Analysis and Design of Current-Fed Push-Pull Resonant Inverter—Cold Cathode Fluorescent Lamp Driver,” IEEE IAS’ 96, pp.2149-2152, Vol. 4, Oct. 1996.

[41] C.S. Moo; W.M. Chen; H.K. Hsieh, “An Electronic Ballast with Piezo-Electric Transformer for Cold Cathode Fluorescent Lamps,” Industrial Electronics Proceedings, ISIE 2001, pp. 36-41

[42] 鄭培璿，“Is Spice在電力電子與電源轉換器上的應用”，全華科技圖書股份有限公司，民國88年。

[43] P. Ueunten, “Resonant Mode CCFL Inverters,” AN-01, Application Note, Monolithic Power System Corporation, 2002.

[44] B. Andreycak, “Designing a Phase Shifted ZVT Power Converter,” Unitrode Power Supply Design Seminar Manual SEM-900, 1993.

[45] O2 Micro International Limited; “Inverter Controller OZ960,” OZ960 Data Sheet Rev. 1. 6, January 2000.

[46] J. Peterson and S. Barney, “Design Issue in Selection of Backlight Inverter,” Endicott Research Group, Inc.

[47] C. Kim, J. Ji and S. Yoon, “A Study on the Design and Performance of Electronic Ballast for CCFL Dimming Control with Frequency Modulation,” Sixth International Conference on Electrical and Systems, Vol. 1, pp. 453-456, November 2003.

[48] JFET-Input Operational Amplifiers TL-084 Data Sheet, Texas Instruments Inc., February 1999.

[49] LM111/LM211/LM311 Voltage Comparator Data Sheet, National Semiconductor Inc., 2000.

[50] Internally Trimmed Precision IC Multiplier AD-534 Data Sheet, Analog Devices Incorporated, 1999.

[51] 黃敏祥，盧明智，“OP Amp 應用+實驗模擬”，全華科技圖書股份有限公司，民國89年。

[52] Standard Power MOSFET IRFP-264 Data Sheet, IXYS Inc., 2000.

[53] Standard Power MOSFET IRFP-460 Data Sheet, IXYS Inc., 2000.

[54] Standard Power MOSFET IRFP-150 Data Sheet, IXYS Inc., 2002.