| 研究生: |
陳永翔 Chen, Yong-Shiang |
|---|---|
| 論文名稱: |
以FPGA實現光伏能量直流/直流轉換模組化之設計 Design and Implementation of Photovoltaic Energy DC/DC Conversion System Based on FPGA |
| 指導教授: |
梁從主
Liang, Zong-jui 陳建富 Chen, Jian-Fu |
| 學位類別: |
碩士 Master |
| 系所名稱: |
電機資訊學院 - 電機工程學系 Department of Electrical Engineering |
| 論文出版年: | 2006 |
| 畢業學年度: | 94 |
| 語文別: | 中文 |
| 論文頁數: | 54 |
| 中文關鍵詞: | 最大功率追蹤 、現場可規劃邏輯閘陣列 |
| 外文關鍵詞: | FPGA, MPPT |
| 相關次數: | 點閱:115 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本文設計一光伏能量直流/直流轉換系統,利用現場可規劃邏輯閘陣列( Field Probrammable Gate Array, FPGA )作為系統控制器,除執行最大功率追蹤控制法則,並針對太陽能電池串聯模組之遮蔽故障做一輔助判斷方法,使光伏系統工作於最大功率點。本文將控制電路整合於FPGA中,有效減少電路元件,並提高系統之穩定度。最後以Verilog HDL 撰寫控制器之架構,以FPGA作為系統控制器進行功能驗證。經實驗可證明本系統無論在正常工作狀態或遮蔽故障時,太陽能電池皆可操作在最佳操作點,有效提升太陽能電池之轉換效率。
The design and implementation of the photovoltaic(PV)energy DC/DC conversion system based on FPGA(Field Programmable Gate Array) is studied in this thesis. For tracking the maximum power point of the partial shading fault of the series solar module, the maximum power point tracking scheme was proposed. In this thesis, the control circuit is integrated in a FPGA chip. It reduces the circuit volume and increases the efficiency of the system. Then, the Verilog HDL code was programmed to the FPGA chip to verify the functions. Finally, experimental results were performed to verify the maximum power point tracking scheme of such a digital controlled PV energy DC/DC conversion system.
[1]洪世淇,「京都議定書生效衍生的國際化商機」,工業技術研究院,民國九十四年二月。
[2]蔡宇泰譯,「太陽能」, 光訊, No.49, pp.16-18, 1994年。
[3]黃秉鈞,「我國太陽能發展的現況與展望」,光訊,第六十八期,1997年10 月。
[4]T. Mishina, H. Kawamura, S. Yamanaka, H. Ohno and K. Naito,“A Study of Automatic Analysis for the I-V Curves of a Photovoltaic Subarray”, Photovoltaic Specialists Conference, Conference Record of the Twenty-Ninth IEEE, 2002.
[5]洪愷威,「實測法及EMTP模型於太陽光伏電池部分遮蔽故障之研究」,國立雲林科技大學電機工程學系,民國九十年六月。
[6]蒲仲偉,「太陽能電池參數分析與部分遮蔽故障之研究」,國立雲林科技大學電機工程學系,民國九十一年六月。
[7]李政勳,「小型太陽光電能能量轉換系統之研製」,國立中山大學電機工程學系,民國九十一年六月
[8]蔡長安,“FPGA Design with ISE Foundation”,國家晶片系統設計中心,民國九十四年一月。
[9] 洪紹恩,「輔以FPGA設計之三相主動電力濾波器之研製」 , 國立成功大學電機工程學系碩士論文, 民國九十年六月。
[10]曾煥堂,「太陽電池之原理與構造」, 電子技術, 1988年。
[11]楊文正,「結晶矽太陽電池之介紹」, 電子技術, 1988年。
[12]吳財福、張健軒、陳裕愷,「太陽能供電與照明系統綜論」,全華,2003年2月。
[13]Y. Yusof, S. H. Sayuti, M. A. Latif, and M.Z.C. Wanik, “Modeling and Simulation of Maximum Power Point Tracker for Photovoltaic System”, Power and Energy Conference, pp. 88–93, November, 2004.
[14]陳榮泰,「單相三線式數位化光伏能量轉換系統」, 國立成功大學電機工程學系, 民國九十年六月。
[15]黃國建, 「追蹤式光伏能量轉換系統之研究」, 國立成功大學電機工程學系,民國八十六年六月。
[16]K. Irisawa, T. Saito, I. Takano, and Y. Sawada, “Maximum Power Point Tracking Control of Photovoltaic Generation System under Non-Uniform Insolation by Means of Monitoring Cells”, Photovoltaic Specialists Conference, Conference Record of the Twenty-Eighth IEEE, pp.1707– 1710, September, 2000.
[17]H. Nagayoshi and M. Atesh, “Partial Shading Effect Emulation Using Multi Small Scale Module Simulator Units ” Photovoltaic Specialists Conference,Conference Record of the Thirty-first IEEE, pp.1710– 1713, January, 2005.
[18]K. Kobayashi, I. Takano, and Y. Sawada, “A Study on A Two Stage Maximum Power Point Tracking Control of A Photovoltaic System under Partially Shaded Insolation Conditions, ” Power Engineering Society General Meeting, IEEE, pp.1710–1713 , July, 2003.
[19]邱國偉,“太陽能電力系統故障分析之研究”,國立雲林科技大學電機工程學系,民國九十年六月。
[20]A. Kajihara and T. Harakawa, “Model of Photovoltaic Cell Circuits under Partial Shading” Industrial Technology, IEEE International Conference , pp.866- 870, December .2005.
[21]林灶生,劉紹漢,「Verilog FPGA晶片設計」, 全華,民國九十三年五月。
[22]N. Mohan, T. M. Undeland, and W. P. Roobins , “Power Electronic: Converter, Applications and Design”, John Wiley & Sons, 1989 .
[23]梁適安,“交換式電源供給器之理論與實務設計”,全華,民國九十年十二月。
[24]ADC 0820 Data Sheet, National Semiconductor Inc., June , 1999.
[25]M. A. EL-Shibinu and H. H. Rakha , “Maximum Power Point Tracking Technique,” Electrotechnical Conference, pp. 21-24, April ,1989.
校內:2105-08-30公開