| 研究生: |
許文謙 Hsu, Wen-Chien |
|---|---|
| 論文名稱: |
具耦合電感及倍壓電路高升壓直流/直流轉換器之研製 Study and Implementation of High Step-Up DC-DC Converter Using Coupled Inductor and Voltage Double Circuit |
| 指導教授: |
陳建富
Chen, Jiann-Fu |
| 學位類別: |
碩士 Master |
| 系所名稱: |
電機資訊學院 - 電機工程學系 Department of Electrical Engineering |
| 論文出版年: | 2012 |
| 畢業學年度: | 100 |
| 語文別: | 中文 |
| 論文頁數: | 68 |
| 中文關鍵詞: | 高升壓 、倍壓電路 、耦合電感 |
| 外文關鍵詞: | high step-up, voltage-double circuit, coupled-inductor |
| 相關次數: | 點閱:83 下載:3 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文提出一新型高效率高升壓直流對直流轉換器,利用耦合電感與倍壓電路,使本轉換器具有架構簡單及高效率等優點,在較小的開關責任週期內可得到高升壓比。本文首先說明電路之動作原理,並分析此轉換器其耦合電感在不同匝數比下的效率及電壓轉換比,以得到較佳之系統參數。最後,研製一輸入電壓24 V,輸出電壓為200 V,輸出功率100 W之電路雛型,並由實驗結果驗證理論分析之可行性。
In this thesis, a novel high efficiency high step-up DC-DC converter is presented. The coupled-inductor and voltage-double circuit are integrated in the proposed converter. The power converter not only achieve high voltage ratio with appropriate duty cycle but also has advantages of simple structure and high efficiency like boost converter. The analysis of operating principle of this converter is performed at first. Then, the turn-ratio of the coupled-inductor is discussed for voltage ratio and the efficiency of the proposed converter. Finally, a prototype circuit with 24 V input voltage, 200 V output voltage and 100 W output power is implemented to verify the performance of the proposed converter.
R. J. Wai and R. Y. Duan, “High-Efficiency DC/DC Converter with High Voltage Gain,” In proc.IEEE EPA Conference, vol. 152, no. 4, pp. 793-802, 2005.
[2] L. Wuhua, L. Xiaodong, Y. Deng, J. Liu and X. He, “A Review of Non-Isolated High Step-Up DC/DC Converter in Renewable Energy Applications,” in proc. IEEE APEC Conference, pp. 364-369, 2009.
[3] K. B. Park, H. W. Seong, H. S. Kim, G. W. Moon and M. J. Youn, “Integrated
Boost-Sepic Converter for High Step-Up Applications,” in proc. IEE PESC Conference, pp.944 - 950, 2008.
[4] F. L. Luo, “Positive Output Luo Converters: Voltage Lift Technique,” on Electric Power Applications, in Proc. IEE EPA Conference, vol. 146, no. 4, pp. 415 - 432, 1999.
[5] A. Ioinovici, “Switched-capacitor Power Electronics Circuits,” IEEE Trans. On Circuits and System, vol. 1, no. 4, pp. 37-42, 2001
[6] Y. Berkovich and B. Axelrod, “Switched Coupled-inductor Cell for DC/DC
Converters with Very Large Conversion Ratio,” IET Trans. On Power Electronics, vol. 4, no. 3, pp. 305-315, 2011.
[7] T. J. Liang and K. C. Tseng, “Analysis of Integrated Boost-Flyback Step-Up
Converter,” in Proc. on EPA Conference, vol. 152, no. 2, pp. 217-225, 2005.
[8] Q. Zhao and F. C. Lee, “High-Efficiency, High Step-Up DC/DC Converters,”
IEEE Trans. on Power Electronics, vol. 18, no. 2, pp. 65-73, 2003.
[9] K. Yasui, I. Hirota, T. Iwai, H. Omori, N.A. Ahmed, T.A. Ahmed and H.
Sugimura, “New Boost-Active Clamp One-Stage Soft Switching PWM High
Frequency Inverter Using Trench-Gate IGBTs,” in Proc. IEE IECON, vol. 16, pp. 6, 2005
[10] X. Wu, J. Zhang, X. Ye and Z. Qian, “A Family of Non-Isolated ZVS DC–DC
Converter Based on A New Active Clamp Cell,” In proc. IEE IECON , 2005
[11] R. J. Wai, L. W. Liu and R. Y. Duan, “High-Efficiency Voltage-Clamped
DC-DC Converter with Reduced Reverse-recovery Current and Switch Voltage Stress,” IEEE Trans. on Industrial Electronics, vol. 53, no. 1, pp. 272–280, 2006.
[12] 吳志鋐,陳建富,鄭銘揚,「交錯式二次側磁重置順向轉換器之研製」,
國立成功大學電機工程研究所碩士論文,中華民國97年6月。
[13] E. H. Ismail, M. A. Al-Saffar and A. J. Sabzali, “High Conversion Ratio DC-DC Converters with Reduced Switch Stress,” IEEE Trans. on Circuits and Systems-I, vol. 55, no. 7, pp. 2139-2151, 2008.
[14] R. J. Wai, C. Y. Lin, R. Y. Duan and Y. R. Chang, “High-Efficiency DC-DC
68
Converter with High Voltage Gain and Reduced Switch Stress,”IEEE
Trans. on Industrial Electronics, vol 54, no 1, pp. 354 - 364, 2007. [15] S. U. Seo, K. J. Lee, R.-Y. Kim and D. S. Hyun, “Aggregated Modeling and Control of Integrated Boost-Flyback High Step-Up Converter,” in Proc. IEEE IECON , pp. 1191-1196, 2011. [16] P. H. Kuo, T. J. Liang, K. C. Tseng, J. F. Chen and S. M. Chen, “An Isolated High Step-Up Forward/Flyback Active-Clamp Converter with Output Voltage Lift,” in Proc. IEEE ECCE Conference, pp. 542-548, 2010. [17] J. Leyva-Ramos, M. G. Ortiz-Lopez, L. H. Diaz-Saldierna and M. Martinez-Cruz, “Average Current Controlled Switching Regulators With Cascade Boost Converters,” IET Trans. on Power Electronics, vol 4, no 1, pp. 1 - 10, 2011.
[18] F. L. Luo and H. Ye, “Positive Output Super-lift Luo-converters” IET Trans. on Power Electronics, vol. 18, no. 1, pp. 105-113, 2003.
[19] Q. Zhao, F. Tao, and F. C. Lee, “A Front-end DC/DC Converter for Network
Server Applications,” in Proc. IEEE PESC Conference, vol. 3, pp. 1535-1539, 2001
[20] K. Harada, T. Ninmomiya and M. Kohno, “Optimum Design of RC Snubbers for Switching Regulators” IEEE Trans. on Aerospace and Electronic. System, vol. AES-15, no. 2, pp.209-218, 1979.
[21] Q. Zhao, F. Tao, Y. Hu and F. C. Lee, “Active-clamp DC/DC Converters Using Magnetic Switches,” in Proc. IEEE APEC Conference, vol. 2, pp. 946-952, 2001. [22] C. M. Hong, L. S. Yang, T. J. Liang, and J. F. Chen, “Novel Bidirectional DC-DC Converter with High Step-Up/Down Voltage Gain,” in Proc. IEEE ECCE Conference, pp. 60-66, 2009.
[23] Q. Zhao and F. C. Lee, “High Performance Coupled-Inductor DC-DC
Converters,” in Proc. IEEE APEC Conference, vol. 1, pp. 109-113, 2003.
[24] J. W. Baek, M. H. Ryoo, T. J. Kim, D. W. Yoo and J. S. Kim, “High Boost
Converter Using Voltage Multiplier,” in Proc. IEEE IECON, pp. 567-572, Nov. 2005.