| 研究生: |
趙興國 Chao, Hsing-Kuo |
|---|---|
| 論文名稱: |
應用於光伏系統之直流/直流模組化轉換器研製 Implementation of a DC/DC Modular Converter for Photovoltaic System |
| 指導教授: |
陳建富
Chen, Jiann-Fuh 林瑞禮 Lin, Ray-Lee |
| 學位類別: |
碩士 Master |
| 系所名稱: |
電機資訊學院 - 電機工程學系 Department of Electrical Engineering |
| 論文出版年: | 2006 |
| 畢業學年度: | 94 |
| 語文別: | 中文 |
| 論文頁數: | 74 |
| 中文關鍵詞: | 光伏系統 |
| 外文關鍵詞: | photovoltaic system |
| 相關次數: | 點閱:45 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文主要在研製不需外加輔助電源於控制電路之應用於光伏系統直流/直流模組化轉換器,另外採用感測電阻取代霍爾感測器來偵測電流,藉此減少電路元件成本、降低體積與增加電路效益。文中並估算太陽能模組在不發電情形下,電路能夠減少之能源損耗。當照度、溫度隨著陽光強弱改變時,利用PIC控制器實現最大功率追蹤。本文也探討將最大功率偵測點置於轉換器輸出端對於轉換器輸入功率以及輸出功率的影響,並以模擬及實驗佐證。最後,實作完成兩組75W之轉換器,當最大功率追蹤偵測點置於轉換器輸出端時,轉換器的輸入功率較低、但是以轉換器輸出功率45W為例,兩種偵測方式誤差在 0.6W內。
In this thesis, a DC/DC modular converter for photovoltaic system is studied and implemented. In order to reduce the volume and cost, the converter doesn’t need any auxiliary power in control circuit. The converter uses a resistor to sense current signal instead of Hall sensor in addition. The reduced losses were estimated when the PV module didn’t generate power. As intensity of illumination and temperature varied with sunlight, the maximum power point of PV module were traced based on PIC microprocessor. It is also comparing the effect of the input power and output power with the different sensor point of MPP in this thesis. And then, they were simulated and verified with experimental results. Finally, when the sensor point is at the output terminal of the converter, experimental results show that the input power of the converter was lower. But the error of the different sensor point results was within 0.6W at output power was 45W.
[1] 張品全,「太陽能電池」科學發展,349期,22-29頁,91年。
[2] 熊谷秀,「太陽光電知多少」,科學發展,383期,34-41頁,93年。
[3] 經濟部能源局,「能源政策白皮書」。
[4] 楊素華、蔡泰成,「太陽光能發電元件」,科學發展,390期,50-55頁,94年。
[5] 楊文正,「結晶矽太陽能電池之介紹」,電子技術,29期,74-80頁,77年。
[6] 謝大德,「整合建築之太陽能光伏系統效益分析」,國立成功大學電機工程研究所碩士論文,94年。
[7] 吳財福、張建軒、陳裕愷,「太陽能供電與照明系統綜論」,全華,89年。
[8] 王耀諄、邱國偉,「太陽能電池EMTP模型之建立」,電力電子技術雙月刊,90年10月。
[9] D. J. Caldwell, “Generalized Stability Criteria for Negative Impedance Loads,” IECEC 91, pp25-29, 1991.
[10] 林忠榮,「太陽能電池儲能系統之研製」,國立雲林科技大學電機工程研究所碩士論文,85年。
[11] 黃國建,「追蹤式光伏能量轉換系統之研究」,國立成功大學電機工程研究所碩士論文,86年。
[12] 郭永超,「單級式光伏能量轉換系統之設計與研製」,國立成功大學電機工程研究所博士論文,90年。
[13] 林豐盛,「以FPGA實現單級式光伏能量轉換系統」,國立成功大學電機工程研究所碩士論文,93年。
[14] 蔡知達,「單級光伏能量轉換系統之控制晶片設計」,國立成功大學電機工程研究所碩士論文,94年。
[15] C. Hua, J. Lin, and C Shen, “Implementation of a DSP-Controlled Photovoltaic System with Peak Power Tracking,” IEEE Transactions on Industrial Electronics, Vol.45, No.1, pp.99-107, 1998.
[16] J. A. Jiang, T. L. Huang, Y. T. Hsiao, and C. H. Chen, “Maximum Power Tracking for Photovoltaic Power Systems,” Tamkang Journal of Science and Engineering, Vol. 8, No. 2, pp.147-153, 2005.
[17] 梁適安,「交換式電源供給器之理論與實務」,全華,90年。
[18] N. Mohan, T. M. Undeland, and W. P. Robbins, Power Electronics, John Wiley &Sons Inc., 1995.
[19] E. Koutroulis, K. Kalaitzakis, and C. Nicholas “Development of a Microcontroller-Based, Photovoltaic Maximum Power Point Tracking Control System,” IEEE Transactions on Power Electronics, Vol.16, No.1, pp.46-54, 2001.
[20] M. Veerachary, T. Senjyu, and K. Uezato, “Voltage-Based Maximum Power Point Tracking Control of PV System,” IEEE Transactions on Aerospace and Electronic systems, Vol.38, No.1, pp.262-269, 2002.
[21] M. Veerachary, T. Senjyu, and K. Uezato, “Maximum Power Point Tracking Control of IDB Converter Supplied PV System,” IEE Proceedings-Electric Power, Vol.148, No.6, pp.494-502, 2001.
[22] 李勝泰,「太陽光發電系統之最大輸出功率控制」,國立清華大學電機工程研究所碩士論文,86年。
[23] Y. C. Kuo, T. J. Liang, and J. F. Chen, “Novel Maximum Power Point Tracking Controller for Photovoltaic Energy Conversion System,” IEEE Transactions on Industrial Electronics, Vol.48, No.3, pp.594-601, 2001.
[24] K. H. Hussein, I. Muta, T. Hoshino, and M. Osakada, “Maximum Photovoltaic Power Tracking: an algorithm for rapidly changing atmospheric conditions,” IEE Proceedings-Generations Transmissions and Distributions, Vol.142, No.1, pp.59-64, 1995.
[25] M. Veerachary, T. Senjyu, and K. Uezato, “Maximum Power Point Tracking of Coupled Inductor Interleave Boost Converter Supplied PV System,” IEE Proceedings-Electric Power, Vol.150, No.1, pp.71-80, 2003.
[26] JHR Enslin, MS Wolf, DB Snyman, and W. Swiegers, “Integrated Photovoltaic Maximum Power Point Tracking Converter,” IEEE Transactions on Industrial Electronics, Vol.44, No.1, pp.769-773, 1997.
[27] N. Femia, G. Petrone, G. Spagnuolo, and M. Vitelli, “Optimization of Perturb and Observe Maximum Power Point Tracking Method,” IEEE Transactions on Power Electronics, Vol.20, No.4, pp.963-973, 2005.
[28] 何信龍、李銀雪,「PIC16F87X 快速上手」,全華,89年。
[29] 施慶隆,「PIC16F87X 微控制器原理實習與專題應用(修訂版)」,全華,92年。
[30] Microchip PIC16F87X Datasheet
[31] 林志一、曾龍圖,「IsSpice Version8交談式電路模擬分析與應用」,全華,90年。
[32] 鄭培璿,「IsSpice在電力電子與電源轉換器上的應用(修訂版)」,全華,92年。
[33] B. H. Cho, J. R. Lee, and F. C. Y. Lee, “Large-Signal Stability Analysis of Spacecraft Power Processing System,” IEEE Transactions on Power Electronics, Vol.5, No.1, pp.110-116, 1990.
[34] 陳建富、歐文生、何明錦、林國榮,「整合型太陽能光電板結合建築外殼之效益分析」,台電年度論文專輯,379-398頁,95年。
[35] 蒲仲偉,「太陽能電池參數分析與部分遮蔽故障之研究」,國立雲林科技大學電機工程研究所碩士論文,93年。
校內:2105-08-17公開