簡易檢索 / 詳目顯示

研究生: 江孟璋
Chiang, Meng-Chang
論文名稱: 配電閉環路保護模擬與電壓驟降特性之探討
Protection Simulation and Voltage Sag Characteristic Analysis for Close-Loop Distribution Systems
指導教授: 陳建富
Chen, Jian-Fu
梁從主
Liang, Tsorng-Juu
學位類別: 碩士
Master
系所名稱: 電機資訊學院 - 電機工程學系碩士在職專班
Department of Electrical Engineering (on the job class)
論文出版年: 2007
畢業學年度: 95
語文別: 中文
論文頁數: 89
中文關鍵詞: 電壓驟降保護電驛常閉環路
外文關鍵詞: close-loop, protection relay, voltage sags
相關次數: 點閱:110下載:9
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 本文係是利用 Matlab/Simulink 軟體模擬驗證台南科學園區22.8kV配電閉環路系統,當故障發生時智慧型電子裝置(Intelligent Electronic Device, IED)之保護跳脫機制,並針對閉環路系統其饋線、匯流排及分岐線等故障類型保護模擬,以探究保護電驛跳脫動作時間是否協調且符合台電要求,並分析其可能造成之風險。同時對常閉環路與常開放射型故障發生時的電壓驟降大小與相位變化產生之影響進行分析,期能對相關單位於電壓驟降改善方面有所助益。
    經由模擬結果比對其各保護區間發生故障時,IED電驛保護動作皆可符合要求內跳脫完成,並且以南科閉環路系統的實際故障案例與模擬系統進行分析比較,以對模擬系統的正確性得到確認。

    This thesis utilizes the Matlab/Simulink software simulation to prove the intelligent electronic device (IED) function is used in protection at the fault, for 22.8kV distribution of close-loop in Tainan Science Park. The simulation gives some fault types such as feeders, busbars, branch lines and so on. From the simulation results, the trip time of relay accords with the regulations of Taiwan Power Company and the risks were analyzed. It also gives an analysis about the effect on voltage sags between magnitude and phase change, and it benefits to improve voltage sags.
    The results of simulation accords with the standard of Taiwan Power as protection zone occured faults. The IED protect movement accords with the regulation. Comparing the case of field failure and established simulation system in Tainan Science Park, the verification of system is adopted in Matlab/Simulink plans.

    目 錄 摘要 I Abstract II 誌謝 III 目錄 IV 圖表索引 VII 第一章 緒論 1 1.1 研究背景與動機 1 1.2 研究目的3 1.3 內容概述5 第二章 配電系統型態5 2.1 型態概述5 2.2 放射連絡型系統 5 2.3 常開環路系統6 2.4 一次選擇型系統 8 2.5 重點網路系統9 2.6 常閉環路型系統 10 2.7 各種配電系統型態之比較 11 2.8 配電線路規劃設計原則12 第三章 電驛保護功能範例與分析 15 3.1 電驛基本架構 15 3.2 保護電驛之分類 16 3.3 保護電驛之國際代碼與功能17 3.4 過電流電驛之原理與應用 19 3.5 方向性過電流電驛之原理與應用25 3.6 差動電驛之原理與應用29 3.7 載波電驛之原理與應用31 第四章 南科常閉配電環路保護模擬35 4.1 南科供電系統概述35 4.2 閉環路配電保護之規劃 37 4.2.1饋線保護38 4.2.2匯流排保護39 4.2.3分歧線保護40 4.3 利用MATLAB/SIMULINK建構系統與模型 41 4.3.1 過電流電驛/方向性過電流電驛42 4.3.2 POTT/DCB載波電驛46 4.3.3 CBFP與DTT之後衛保護50 4.3.4 匯流排電驛51 4.3.5 IED電驛模擬整合52 4.4 模擬結果及分析53 4.4.1 系統架構53 4.4.2 元砷-台鹽間饋線故障模擬分析54 4.4.3 台鹽間匯流排故障模擬分析58 4.4.4 台鹽分歧線故障模擬分析62 4.4.5 實際故障案例分析65 4.5 综合結果68 第五章 常閉環路/放射式供電電壓驟降分析71 5.1電壓驟降概述71 5.2 常閉/放射型配電系統之電壓驟降模擬 73 5.3 電壓驟降之改善 78 5.4 模擬結果分析 82 第六章 結論及未來研究方向83 6.1 結論 83 6.2 未來研究方向 84 參考文獻 86

    參考文獻
    [1]莊志鴻,「應用Matlab/Simulink於常閉環路配電系統IED保護策略之研究」,國立台灣科技大學碩士論文,民國92年6月。
    [2]Settembrini, R. “Seven Distribution System:How Reliabilities Compare” Electrical World, pp.41-45, May 1992.
    [3]Gilligan, S. R. “A Method for Estimating The Reliability of Distribution Circuit ”, IEEE Trans. On power Delivery. Vol. 7, No. 2, pp. 694-698, April 1992.
    [4]Tobias, J. C.,Sautriau, F. and Hull, D.J.and Fabraay, S. “Improved Quality of Supply in MV Distribution Networks Using Directional Blocking Scheme,” IEE Conference Publication No.438, 1997.
    [5]Tobias, J.C. ,Leeuwerke, R.P. and Brayford, A.L. and. Robinson, A. “The Use of Sectionalising Circuit Breakers in Urban MV Distribution Network,” IEE Conference Publication No. 459, Trends in Distribution Switchgear, pp.102-108, 1998.
    [6]Tobias, J.C. ,Barrett, A.C. and Brayford, A..L. “Configurable Multifunction Protection and Control Unit Design and Application,” IEE Colloquium on Design Technology of T&D, 1998.
    [7]張源吉,「利用Matlab/Simulink模擬含分散型風力電源閉環路配電系統保護」,國立台灣科技大學碩士論文,民國93年6月。
    [8]Barry P. “Energizing International Drive,” Transmission & Distribution World, pp.18-29, 2000.
    [9]Kezunovic, M. “User-friendly, Open-system Software for Teaching Protective Relaying Application and Design Concepts,” IEEE Transactions on Power Systems, Vol.18, pp986 -992, 2003.
    [10]Hoang, L. H. “Modeling and Simulink of Electrical Drives using MATLAB/Siulink and Power System Blockset,” Industrial Electronics Society, The 27th Annual Conference of the IEEE, Vol.3, 2001.
    [11]視覺化建模環境Simulink入門與進階,鈦思科技股份有限公司,民國90年11月。
    [12]The MathWorks, Inc., “Power System Blockset User’s Guide,” Version 3, 2002.
    [13]配電系統規劃準則,台灣電力公司,民國93年3月修訂
    [14]配電技術手冊(一),台灣電力公司,民國80年1月
    [15]黃泉發,「南科161kV環路後衛保護協調及系統電壓驟降模擬」,國立成功大學碩士論文,民國95年6月
    [16]江榮成,「保護協調實務與模擬」,民國94年工業技術人才培訓講義。
    [17]林義讓、林清樺編著,「電機設備保護」,全華科技圖書股份有限公司,民國81年5月再版。
    [18]李宏任,實用保護電驛,全華科技圖書,民國89年。
    [19]IEEE Std. C37.1-1994, IEEE Standard Definition, Specification, and Analysis of Systems Used for Supervisory Control, Data Acquisition, and Automatic Control, New York, 1996.
    [20]IEEE Std. C37.2-1996, IEEE Standard Electrical Power System Device Function Numbers and Contact Designations, New York, 1996.
    [21]ETAP POWERSTATION SOFTWARE, Operation Technology. Inc., Southern California, USA, 2002.
    [22]陳順斌,「電力系統方向性過電流與測距電驛之最佳保護協調」,國立台灣科技大學碩士論文,民國88年6月。
    [23]李河樟,「線路保護方式方向比較 POTT」,中華民國電驛協會會刊第九期,pp 43-56,民國89年。
    [24]莊宗霖,「智慧型電子裝置應用於閉環路配電系統之保護」,國立台灣科技大學碩士論文,民國90年6月。
    [25]台電公司嘉南供電區處九十四年度計畫,「建立台南科學園區電力系統診斷模示以強化供電可靠之研究」,民國94年8月。
    [26]陳在相,蒲冠志,楊文治,黃維澤,林金順,蔡金龍,于尚禮,許炎豐,「配電系統採常閉環路可行性研究完成報告」,電力综合研究所電力,民國88年10月。
    [27]陳在相,辜志承,蒲冠志,黃維澤,沈混源,游伯煌,趙恒寬莊宗霖,許炎豐,「配電系統採同一主變常閉環路之建置完成報告」,台灣電力股份有限公司研究計畫,pp 1~40,民國90年。
    [28]辜志承,陳在相,沈混源,黃維澤,莊宗霖,趙恆寬,敦宗益,蒲冠志,許炎豊,「環路式配電系統之保護協調分析」,第23屆電力研討會論文集,民國91年12月。
    [29]羅天賜,「電壓驟降概論 」,工業技術研究院能源與資源研究所。
    [30]黃瓊誼,高科技產業高標準之電力需求,電機月刊第113期,pp 284-297,民國89年5月。
    [31]SEMI F47-0200, Specification for Semiconductor Processing Equipment Voltage Sag Immunity, SEMI February 2000.
    [32]Schwartzenberg, J. W. De Doncker, R. W. "15 kV Medium Voltage Static Transfer Switch," Proceedings of the 30th IEEE Industry Application Annual Meeting, Vol. 3, pp. 2515-2520, 1995.
    [33]Divan, D. Sutherland, P. Grant, T. McGranaghan, M. and Zavadll, R. "Dynamic Sag Corrector: A New Concept in Power Conditioning," Power Quality Assurance Magazine, October 1998.

    下載圖示 校內:2008-08-21公開
    校外:2010-08-21公開
    QR CODE